Posted on: March 16, 2020 Posted by: admin Comments: 0


Canon Timer Remote Controller TCN3 compared to the Canon Remote Switch . Note that I usually use and recommend manual focus while using a remote. View and Download Canon TCN3 user manual online. Timer remote controller. TCN3 Camera Accessories pdf manual download. Hi Is it possible to download a pdf version of the instruction manual for the Canon TCN3 Timer Remote Controller? If so a link would be.

Author: Arara Goktilar
Country: Costa Rica
Language: English (Spanish)
Genre: Relationship
Published (Last): 18 March 2009
Pages: 56
PDF File Size: 19.79 Mb
ePub File Size: 8.40 Mb
ISBN: 739-1-33316-846-6
Downloads: 90251
Price: Free* [*Free Regsitration Required]
Uploader: Kagazilkree

Zach Wise at www.

Canon’s DSLRs unfortunately allow specified exposure time lengths of only up to 30 seconds. Press manyal Jog Dial to select the time unit you wish to set.

Exposure count is set similarly, except there is fanon one value to set. This instant release button is always available and can be slid forward while depressed to lock in the depressed state called “running lock” which hold the shutter open if the camera is in Bulb mode. Interval Timer Mode 1.

If your camera has a removable N3 port cover, it can be plugged into a small hole in the back of the TCN3. Click on the link for the video.

Canon Timer Remote Controller TC-80N3 Review

Self-Timer Interval Timer Long Exposure Control Exposure Count Control Use the Self-Timer function to delay the start of an exposure for a specific length of time — from 1 second to 99 hours, 59 minutes and 59 seconds. Repeat Step 3 for any additional time units you wish to set. Each time you press the dial, the canom units will blink in the following order: Was this article helpful?


Not as obvious and a user interface design error in my opinion is that, when depressed for at least 3 seconds, the Display Illumination button invokes a “hold” mode.

Where you buy your gear matters. Canon’s mid and high end cameras have one. Unless you specify a specific interval, the exposures will be taken at one-second intervals.


It is unlikely that many of us will ever need to exceed that longer timespan. Subsequent exposures will be at the interval you have set.

The exposure will start, the icon will blink and the exposure time will begin to count down. The cord length is 2.

A battery icon will show when battery is low and will blink when the battery is very low.

QuickGuide to Canon TC-80N3 Timer/Remote Controller

Please enable javascript in your browser in order to manua form work properly. For example, you can program the controller to wait five minutes, release the shutter, then take a total of 25 exposures at five minute intervals.


While 30 seconds can cover a high percentage of DSLR uses, there are situations that need longer exposures — such as those often encountered when using an above-mentioned stop neutral density filter.

Send a message to jared1. Press it again to resume. As with your camera’s shutter button, you can press the Release Button either halfway or all the way. When using flash with the interval timer, be sure to allow enough time for the flash es to adequately charge between shutter releases.

Flash, Lighting and Accessories. This remote release requires no smart phone, tablet or other computer to make it work. To release the button, slide it back to its original position.

Press the Jog Dial.

Canon Timer Remote Controller TCN3 Review

When the time unit you wish to set is blinking, turn the Jog Dial to the amount you want. Renting is fast and easy. When you are shooting with electronic flash the time interval you set must be longer than the flash recycle time. You are going to send email to.

I suggest testing it out a few times before putting it to work.


Leave a Comment